耐硫催化剂上合成混合醇的研究

通过改进制备方法和添加助剂，用浸渍－热分解法制得了具有高活性和高选择性的MoS2-K-C型耐硫低碳混合醇催化剂。在8.0-11.0MPa,290-340℃，6000-12000h^-1,H2 S 浓度为100ppm 左右的条件下，在直流反应器中对催化剂进行了性能测试，结果表明，醇得率为0.14-0.47gROH(gcat·h)^-1，选择性为89-98%。同时，考察了操作条件对催化剂性能的影响。1042h的试验，证明催化剂具有很好的稳定性。     

Synthesis, X-ray crystal structures, and gas sorption properties of pillared square grid nets based on paddle-wheel motifs: implications for hydrogen storage in porous materials

A systematic modulation of organic ligands connecting dinuclear paddle-wheel motifs leads to a series of isomorphous metal-organic porous materials that have a three-dimensional connectivity and interconnected pores. Aromatic dicarboxylates such as 1,4-benzenedicarboxylate (1,4-bdc), tetramethylterephthalate (tmbdc), 1,4-naphthalenedicarboxylate (1,4-ndc), tetrafluoroterephthalate (tfbdc), or 2,6-naphthalenedicarboxylate (2,6-ndc) are linear linkers that form two-dimensional layers, and diamine ligands, 4-diazabicyclo[2.2.2]octane (dabco) or 4,4'-dipyridyl (bpy), coordinate at both sides of Zn(2) paddle-wheel units to bridge the layers vertically. The resulting open frameworks [Zn(2)(1,4-bdc)(2)(dabco)] (1), [Zn(2)(1,4-bdc)(tmbdc)(dabco)] (2), [Zn(2)(tmbdc)(2)(dabco)] (3), [Zn(2)(1,4-ndc)(2)(dabco)] (4), [Zn(2)(tfbdc)(2)(dabco)] (5), and [Zn(2)(tmbdc)(2)(bpy)] (8) possess varying size of pores and free apertures originating from the side groups of the 1,4-bdc derivatives. [Zn(2)(1,4-bdc)(2)(bpy)] (6) and [Zn(2)(2,6-ndc)(2)(bpy)] (7) have two- and threefold interpenetrating structures, respectively. The non-interpenetrating frameworks (1-5 and 8) possess surface areas in the range of 1450-2090 m(2)g(-1) and hydrogen sorption capacities of 1.7-2.1 wt % at 78 K and 1 atm. A detailed analysis of the sorption data in conjunction with structural similarities and differences concludes that porous materials with straight channels and large openings do not perform better than those with wavy channels and small openings in terms of hydrogen storage through physisorption.     

Photochemical Synthesis and Spectral-Optical Characteristics of ZnO/Cu and ZnO/Ag/Cu Nanoheterostructures

The photoreduction of Cu²⁺ at the surface of ZnO nanoparticles and ZnO/Ag nanostructures was investigated. The spectral characteristics of the obtained ZnO/Cu and ZnO/Ag/Cu composites were studied in relation to the reaction conditions. It was shown that the ZnO/Ag nanoparticles have higher photocatalytic activity in the reduction of Cu²⁺ ions than the individual ZnO particles.     

含铜三元类水滑石化合物的合成及其性质

 以Cu（NO3）2，Zn（NO3）2和Al（NO3）3为原料，以NaOH为沉淀剂，利用共沉淀法合成了含铜三元类水滑石化合物CuZnAl－HTLcs．从不同Cu／Zn／Al比的混合原料溶液的滴定曲线入手，详细探讨了溶液pH值、原料加入方式、组分配比及水热处理条件对类水滑石合成的影响，利用XRD，ICP及比表面积测定对合成物进行了表征，并以苯酚羟基化为探针反应评价了催化剂的催化性能．结果表明，在体系pH＝5．0～6．2，（Cu＋Zn）／Al摩尔比＝2．0，Cu／Zn摩尔比≤1．0及室温条件下共沉淀后，于100℃水热处理3h，即可得到晶相单一和结晶度高的CuZnAl－HTLcs．变化pH法合成的样品的相对结晶度为100％，低过饱和法为76．5％，高过饱和法为75．9％．合成的CuZnAl－HTLcs中Cu2＋的含量均比原料液中Cu2＋的含量有所增加，这可能是由于在pH＝5．8时Cu2＋对Al（OH）3的同晶取代能力比Zn2＋强．随着CuZnAl－HTLcs中Cu含量的增加，催化剂对苯酚羟化反应的催化活性逐渐增大．     

Nitro-PAPS分光光度法测定葡萄糖酸锌

为建立一种快速、简便、灵敏分光光度法测定葡萄糖酸锌方法,在非离子型表面活性剂聚氧乙烯失水山梨醇油酸单脂(Tween-80)及聚氧乙烯异辛基苯基醚(TritonX-100)存在下,用水溶性试剂2-(5-硝基-2-吡啶偶氮)-5-[N-正丙基-N-(3-磺酸丙基)氨基]苯酚二钠(简称Nitro-PAPS)作显色剂直接光度法测定葡萄糖酸锌。结果表明,该法显色络合物最大吸收波长为580nm,本法线性范围为0~1μg/mL,表观摩尔吸光数为1.41×105L.mol-1.cm-1,回收率为98.5%~102.8%。该法具有操作快速、简便、结果灵敏可靠等优点,应用本法直接测定补锌口服液葡萄糖酸锌含量,结果满意。     

纳米Zn-Co铁氧体的固相合成及电磁损耗特性研究

采用NH₄HCO₃与FeCl₃·6H₂O，Zn(NO₃)₂·6H₂O，Co(NO₃)₂·6H₂O进行室温固相反应制得前驱物，经微波加热处理后，进而热分解分别制得复合氧化物ZnFe₂O₄、CoFe₂O₄和Co_0.5Zn_0.5Fe₂O₄。由激光粒度分析仪、XRD和SEM表征：获得了颗粒分布比较均一、平均粒度为65 nm左右、立方晶系尖晶石结构的纳米铁氧体粉体。经测试样品的相对介电常数和相对磁导率后，研究了它们的电磁损耗特性。结果表明：Co_0.5Zn_0.5Fe₂O₄在100～1 800 MHz内比另外两种铁氧体具有更好的电磁损耗特性。     

酯交换法合成碳酸二苯酯用氧化铅－氧化锌催化剂的研究

 制备了一种用于苯酚与碳酸二甲酯酯交换合成碳酸二苯酯的新型氧化铅－氧化锌多相催化剂．研究了制备方法、焙烧温度、不同母体和母体配比对催化剂催化性能的影响．应用XRD，TPR和原子吸收光谱对催化剂结构进行了表征，发现Pb3O4是主活性物相，ZnO为助催化剂，并以非晶态或微晶态存在于催化剂体系中．当焙烧温度为500℃，n（Pb）／n（Zn）≈2时，催化剂的活性最高，碳酸二苯酯产率可达45．6％．考察了催化剂的重复使用效果，并对失活原因进行了探讨．     

碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

Thermolysis of reactive oligo(p-phenylene sulfide) containing disulfide bond

Oligo(phenylene sulfide) (OPS) containing one disulfide bond at the end of the chain, which was obtained by the oxidative polymerization of diphenyl disulfide, had a relatively low Td_10%(temperature for 10% weight loss) of 412 °C because of degradation of the disulfide bond. But this thermal cleavage of the disulfide bond promoted the curing reaction through thiophenoxy radical formation. OPS was allowed to react with diiodobenzene at 220 °C. The thermal stability of OPS was improved through the consumption of the disulfide bond and the coupling of the chain.